8 November 2018

santa hat pattern



SANTA HAT

THIS PATTERN IS COPYRIGHT PROTECTED 
 ONLY FOR PERSONAL OR CHARITABLE USE
ITEMS KNITTED FROM THIS PATTERN CANNOT BE SOLD FOR PROFIT
 DO NOT REPRODUCE OR USE FOR ANY COMMERCIAL PURPOSE  


Hat will fit an average size adult head. Dimensions of hat are 18 ins / 46 cm, but will stretch a few inches.

ABBREVIATIONS 
rd(s): round(s)
st(s): stitch(es)
k: knit
p: purl
tog: together
rep: repeat

MATERIALS 
four dpns size 6.5mm  (US 10.5)
stitch marker
red chunky / bulky / 12ply
white chunky / bulky / 12ply
white dk / 8ply  for tassel

Cast on 72 sts in white chunky yarn, divide between three needles (24, 24, 24), join in the rd and place st marker.

Rds 1–8: (k2, p2) rep to end of rd.

Change to red chunky yarn.

Continue with k until work measure 4.5 ins / 11.5 cms from cast on edge.

Next rd: (k10, k2tog) rep to end of rd  (66 sts).

Next 3 rds: k.

Next rd: (k9, k2tog) rep to end of rd  (60 sts).

Next 3 rds: k.

Next rd: (k8, k2tog) rep to end of rd  (54 sts).

Next 3 rds: k.

Next rd: (k7, k2tog) rep to end of rd  (48 sts).

Next 3 rds: k.

Next rd: (k6, k2tog) rep to end of rd  (42 sts).

Next 3 rds: k.

Next rd: (k5, k2tog) rep to end of rd  (36 sts).

Next 3 rds: k.

Next rd: (k4, k2tog) rep to end of rd  (30 sts).

Next 3 rds: k.

Next rd: (k3, k2tog) rep to end of rd  (24 sts).

Next 3 rds: k.

Next rd: (k2, k2tog) rep to end of rd  (18 sts).

Next 3 rds: k.

Next rd: (k1, k2tog) rep to end of rd  (12 sts).

Next 3 rds: k.

Next rd: (k2tog) rep to end of rd  (6 sts).

Next 3 rds: k.

Break yarn thread unto a needle and then through the 6 sts, pull tight and fasten off.

To make the tassel
Cut a piece of cardboard 4 inches by 3 inches. If you prefer a longer tassel then cut a longer piece of card, the length of the card determines the length of the tassel. Wind the white dk yarn around the cardboard approximately 30 times.


Using a long piece of white yarn, thread through the top and tie in a knot. These two yarn ends will be used to attach to the hat.


Remove yarn from card and wrap a length of yarn, a couple of times round the tassel about an inch from the top. Secure with a knot.


    
Loose the two yarn ends in the top of the tassel.



Trim the ends of the tassel and attach to the hat.




OTHER IDEAS FOR DECORATING THE HAT

Add a pompom.


Decorate with bells, beads or buttons and felt holly leaves. Add a knitted piece of mistletoe...the pattern is available in my blog click here



copyright Alison Hogg 2018

No comments:

Post a Comment

Id love to hear what you think about my blog, knits etc.